Elephant Shaped Cutlery Dryer
After having more then 600+ downloads of my previous cutlery dryer model on thingiverse, now i designed this cute Version 2 of the design with a lot of improvements in the design. You dont need supports anywhere except the bottom of the trunk, the rest is gona be a piece of cake for your printer to handle (everything is under 45 degree overhang).
Print it with these settings:-
- 0.2 mm layer height
-15% infill
- Automatic supports (print bed only) set the angle to 50 degrees so the slicer generates supports only under the trunk
- Print at 50mm/sec speed
**Do share your prints on social media with #3dprintinggeek.
**Follow me on instagram @tar1qali.
**checkout my website @ www.3dprintinggeek.net
** Follow me on twitter @3dguydubai
** Subscribe to my YouTube Channel here : https://tinyurl.com/yc4245ln
** Like my facebook page @3dprintinggeek