Pikachu Planter
$7
$7
https://schema.org/InStock
usd
This is my original design of a cute Pikachu Planter. Which have been tried & tested for prints before uploading it here for sale. Print it on any printer with the below print settings.
*** 0.2mm layer height
*** 25% infill
*** Supports (Automatic generated only from bed).The supports are very minimal & only get generated below the hands & the tale. Easy to remove later
*** 3 perimeters outer wall
*** 4 Bottom layers / 4 Top layers
*** There is a drainage whole in the middle of the ball from the inside
Add to wishlist